Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
When splicing the fiber, will you meet the fiber tracking failure?
There are several reasons caused the failure:
Dust on lens
Pressure hammer not working precisely on pressing the fiber
CMOS board malfunction
Dust on CMOS BOARD
How to solve the problem?
Firstly, lets check if V-Groove is clean or not?
The pressure hammer tip point is not on the V-Groove and not pressed on fiber
Under normal circumstances, tip point of pressure hammer should be exactly on the central point of V-groove and press on fiber
Solution:
Loose the screw on pressure hammer and adjust the pressure hammer position, ensure the tip point is exactly on central of V-Groove and press on the fiber.
Splicing again after adjust, looks like the splicing is succeed. Problem fixed.
Tumtec is an independent manufacturer for automatic fusion splicers and fiber cleavers;
Tumtec fusion splicers covering backbone project, single Core Alignment Fusion Splicer, FTTX Fusion Splicer and newly released ribbon splicer.
Newly released: 2019 for portable splicer FST-V1 and 2020 for FST-12R.
Email to this supplier
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
Fill in more information so that we can get in touch with you faster
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.